9
EENNGGLLIISSHH CCCCLL NNDD
FRONT PANEL CONTROLS (CCL ND 8 - CCL 210 ND 8)
IINNPPUUTT
socket to plug in a bass guitar.
GGAAIINN
control + CLIP / LIMIT LED to adjust the input level.
LLIIMMIITTEERR
switch + 2-colored CLIP / LIMIT LED to compress the signal within the preamp.
LLOOWW BBOOOOSSTT
switch + LED to boost the low end.
BBAASSSS
control to boost / cut low frequencies.
PPUUNNCCHH
control for boosting/cutting deep mids.
MMIIDD FFRREEQQ
. control to determine the midrange frequency.
MMIIDD LLEEVVEELL
control to boost / cut the frequency adjusted with the MID FREQ. control.
AATTTTAACCKK
control for boosting/cutting high mids.
TTRREEBBLLEE
control to boost / cut high frequencies.
HHIIGGHH BBOOOOSSTT
switch + LED to boost the highs.
MMUUTTEE
switch + ON / MUTE LED mutes the signal of all outputs except the PHONES and TUNER socket. To avoid
switching noise use the MUTE switch only while no audio signal is being played back.
MMAAS
STTEERR
control determines the main volume level.
PPHHOONNEESS
socket for connecting headphones (min 200 Ohm).
REAR PANEL (CCL ND 8 - CCL 210 ND 8)
MMAAIINNSS IINN AACC
terminal with integrated fuse compartment for connecting the amplifier to mains.
PPOOWWEERR
switch for turning the amplifier on and off.
GGRROOUUNNDDLLIIFFTT
switch disconnects the protective ground line from signal ground. A humming loop may occur when
several devices are hooked up to the same protective ground line and connected by line cables. Use
GROUNDLIFT to eliminate humming loops.
TTUUNNEERR OOUUTT
to connect to a tuner, active when MUTE is enabled.
LLIINNEE OOUUTT
socket allows connecting additional power amplifiers or active cabinets.
EEFFFF
.
LLOOOOPP
for the insertion of an effects unit. Connect EFF. SEND with the input and EFF. RETURN with the output
of the effects device.
DDII PPRREE // PPOOSSTT
switch to route the signal to
DDII OOUUTT
socket PRE (pressed, direct signal from the bass) or POST (released, signal affected by equalizer or
effects loop). Symmetric XLR out to connect to e.g. a mixing console.
SSUUBBSSOONNIICC
switch to cut low frequencies from the power amp (CCL ND: signals below 120 Hz).
SSPPEEA
AKKEERR OOUUTT EEXXTT
. to connect an additional speaker with min 8 Ohm.
SSPPEEAAKKEERR OOUUTT
to connect the amplifier to the speaker.
HHOORRNN AATTTT
. to control horn volume separately.
Retractable handle and wheels make it easy to transport your Warwick Combo.
