ADVANTECH
â„¢
Management Software Setup
29
The following options can be set for either a New Washer or New Dryer
Template
(defaults are listed below the option):
Option Description
Base Cycle Price*
($1.00)
Sets the
Base Cycle Price for a wash or a dry cycle.
Base Cycle Time (cannot
be changed on washer)
Sets the
Base Cycle Time for a wash or a dry cycle.
Value of Coin 1 ($0.25)
Sets the value of coins inserted into the first coin drop or slide.
This field must be filled in.
Value of Coin 2 ($1.00)
Sets the value of coins inserted into the second coin drop or
slide (if necessary).
Coinslide Coin1
(4)
Indicates the number of coins that must be inserted into the
first slide to equal the value of the
Base Cycle Price. This
field must be filled in.
Coinslide Coin2
(0)
Indicates the number of coins that must be inserted into the
second slide to equal the value of the
Base Cycle Price (if
necessary).
Coin Drop Installed** Indicates whether or not a Coin Drop device is installed.
Coin Slide Installed** Indicates whether or not a Coin Slide device is installed.
Aux Device Installed** Indicates whether or not a Smart Card reader is installed.
PDA Enabled
Indicates whether service persons can access the machines
with PDAs. If this options is not enabled (no checkmark), then
PDAs cannot be used.
Start on Start Button**** When enabled allows for Push-to-Start or OPL cycles. ($0.00)
Minimum Coin1 Pulse
(24 milliseconds)***
Sets the minimum number of milliseconds for coins to pass
through the Coin1 drop.
Maximum Coin1 Pulse
(50 milliseconds)***
Sets the maximum number of milliseconds for coins to pass
through the Coin1 drop.
Minimum Coin2 Pulse
(24 milliseconds)***
Sets the minimum number of milliseconds for coins to pass
through the Coin2 drop.
Maximum Coin2 Pulse
(50 milliseconds)***
Sets the maximum number of milliseconds for coins to pass
through the Coin2 drop.
Between Coin Delay
(default 0.2 seconds)***
For machines with coin drops installed, the minimum number
of seconds between the drop of Coin1 and the drop of Coin2.
Enable Daylight
Savings (Disabled)
Indicates whether the machine is set to observe Daylight
Savings Time.
Decimal Point Location
Indicates the location of the decimal point when the price is
displayed on the machine.
* For coin drops and slides, Base Cycle Price must match the mechanical settings of the selected coin acceptor.
** A minimum of one-money accepting mechanism must be selected: Coin Drop, Coin Slide, Aux Device, or OPL
*** For coin-operated machines, use manufacturer’s recommended time settings for individual installation, if an OFF error
code appears on the display during use, the time pulse or delay should be dropped to 0.0
**** For Start On Start Option
a minimum of .01 must be input for the cycle price in order for the 0.00 vend price to
appear in the display of the machine.
