GENERAL CLEANING CHART (Cont’d.)
Control Knobs Mrid detergent 8 water
To remove knobs for cleaning. gently pull forward Wash In
mrld detergent and water Do not use abrasive cleaning agents.
They will scratch finish and remove markings Rinse, dry and
replace
Glass-backguard
Oven Window
Soap 8 ‘Waler
Paste of baking soda
& water
Window cleaning
fluid
or ammonia
End panels, polyester
Grates
Metal finishes-
Aluminum-backguard
base. control panel
Chrome 8 stainless
steel-trim parts
Oven Rack
Soap & water
Detergent 8 water
Soap filled scouring pad
Soap & water
Paste of baking soda
8 water
Soap 8 water
Cleansing powders 8
plastic pads
Soap filled scouring pad
Wash with cloth wrung out in soapy water. Remove stubborn
soil with paste of baking soda an water. To avoid inside stain-
ing of oven door glass, do not oversaturate cloth. Do not use
abrasive materials such as scouring pads, steel wool or pow-
dered cleaning agents. They will damage glass. Rinse with
clear water and dry.
Wash with soap and warm water. Do not use abrasive cleaning
materials, They will scratch finish. Never use oven cleaners.
S:ates are made of porcelain coated steel. They can becleaned
at the sink with detergent and waler or in thedishwasher Clean
stubborn soil with soap filled scouring pad.
Wash with soap and water. Remove stubborn soil with paste of
baking soda and water Do not use abrasive or caustic agents.
They will damage the finish. Restore luster on brushed chrome
only, apply small amount of mineral oil and let stand 5 minutes.
Remove excess oil with a clean cloth.
Clean with soapy water Remove stubborn so11 wrth cleansrng
powder or soap filled scouring pad. Rinse and dry
Porcelain Enamel-
Exterior finishes
Porcelain-enamel Oven
and Lower Broiler
Compartment
(See page 18 for cleaning
instructions of
Continuous Cleaning Oven.)
Mild soap 8 water
Paste of baking soda
8 water
Soap
a
water
Cleansing powders 8
plastic pads
Commercial oven cleaner
Porcelain enamel IS glass fused on metal. It may crack or chrp
wrth misuse. Clean with soap and water when parts are cool
All spillovers, especially acid spillovers, should be wiped up
immediately with a dry cloth. When surface is cool, clean with
warm soapy water. NEVER WIPE OFF A WARM OR HOT
ENAMEL SURFACE WITH A DAMP CLOTH. THIS MAY
CAUSE CRACKING AND CHIPPING. Never use abrasive or
caustic cleaning agents on exterior finish of range.
Wipe acid stains immediately with a dry cloth. Clean oven walls
and bottom with soap and water. Stubborn soil IS removed with
cleansing powders or plastic pad. Do not use metallic cleaning
pads. They will scratch the surface. Commercial oven cleaners
can be used but follow manufacturer’s directions.
Reflector Pans
(Chrome plated steel)
Surface burners
Soap 8 water
Paste of baking soda
8 water
Plastic scouring pad
Soap 8. water
Paste of baking soda
8 water
Plastic scouring pad such
as Tuffy@
Clean pans after each use wrth soap and water. Remove stub-
born stains with baking soda paste and plastic scouring pad.
To prevent scratching the finish, do not use abrasive cleaning
agents. Rinse, dry and replace. NOTE: Pans will permanently
discolor if exposed to excessive heat or if soil is allowed to
bake on
Clean as necessary with warm soapy water. Remove stubborn
soil by scouring with a non-abrasive plastic scouring pad and
a paste of baking soda and water. Clean ports with a straight
pin. Do not enlargen or distort the ports. Do not use a wooden
toothpick. It may break off and clog port. DO NOT CLEAN
BURNERS WITH THE FOLLOWING: Caustic cleaners, steel
wool, abrasive cleaning agents, dishwasher detergent, or metal
polishes. These will damage finish. Do not clean burners 111
dishwasher. Burners can be dried in the oven set at 140” i
(60 ’ C.). CAUTION: Burner and burner tube must be dry before
use.
Vinyl Finishes
Door handle
Manifold panel
Soap 8 water
Never use abrasive or caustic cleaning agents on vinyl finishes
17
