A SERVICE OF

logo

I ,\
Terminal
To
remove surface
unit, lift and pull
straight out.
Hold surface unit level
when replacing.
Removing surface units and reflector bowls:
1 First. be sure the Surface Unit Controls are all “OFF“ and that the
surface units are (001.
2 Set) where the surface units plug into the range? Lift each surface
unit about an inch (2 5 cm) at the edge away from the plug-In
(receptacle). Pull the unit straight away from the plug-in. Do not
wash surface units; they will burn themselves clean during nor-
mal use.
13 Lift out the reflector bol~ls
Replacins reflector bowls and surface units:
Be sire the surface unit controls are on “OFF”
Put the reflector bowls back into their places. Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of rach bowl
5
Prop up the top with
support rod.
Pull to stop. Lift; pull
again.
Hold the surface unit level with the prongs (terminals) pointing at
the plug-in
With the prongs started 1n the plug-in. start pushing in on the surface
unit. At the same time. lift a little on the side of the surface unit that’s
by the plug-in
Make sure the suricice-unit prongs are pushed into the plug-in as far
as they will go ThlJ surface unit will fit into the reflector bowl and be
level when everything has been done right
Cleaning under the cooktop:
To clean the area under the cooktop. lift the front of the cooktop at
the center Raise the swing-up rod to hold it. (Be sure the tip of the rod is
in the notch In the cooktop.) Use warm soapy water and a sponge or cloth.
Scouring powders or any other abrasive cleaner may harm porcelain-
enamel finishes and can xratch chrome.
Be careful not tI 1 raise the cooktop so high that it touches the
control console And dori t drop It. Dropplng the cooktop can chip or crack
a hard porcelain finish. <jr damage side panels and surface units.
Removing the storage drawer:
The drawer below your oven IS meant to store pots and pans.
Never keep anything in there that will burn or melt.
You may want to remove the drawer for cleaning under the range.
Pull it straight out until it jtops. Lift the front and pull some more to get it
over the stop Now sltdcj it out until it stops again. Lift the drawer away
from the range until it slips out of the guides.
To put it back. fit the side rails at the back of the drawer into both
guides on the range
Pu\il
it closed while lifting the front to get past the
stops.
13