2.
Remove
the glass bulb cover in the back
of the oven by pushing the wire holder to
the side and pulling out bulb cover.
3.
Remove
the light bulb from its socket.
Replace
the bulb with a 40-watt appliance
bulb.
4. Replace
the bulb cover and
snap
the
wire holder into place.
Plug in
appliance
or
reconnect
at the main power supply.
NOTE:
The oven light should not be used
during the Self-Cleaning cycle. Use during
the Self-Cleaning cycle will shorten the life
of the bulb.
If You Need Assistance
Or Service
This section is designed to help you save the cost of a service call. Part 1 of this section
outlines possible problems, their causes, and actions you can take to solve each problem.
Parts 2 and 3 tell you what to do if you still need assistance or service. When calling our
Consumer Assistance Center for help or calling for service, please provide a detailed descrip-
tion of the problem, your appliance’s complete model and serial numbers and the purchase
date. (See page 2.) This information will help us respond properly to your request.
1. Before calling for assistance . . .
Performance problems often result from little things you can find and fix without tools of any
kind. Please check the chart below for problems you can fix. It could save you the cost of a
service call.
PROBLEM
Nothing will
operate
POSSIBLE CAUSE
SOLUTION
The power cord is not
Plug the power cord into a live circuit
plugged into a live circuit with
with proper voltage. (See Installation
proper voltage.
Instructions.)
Range is not properly con-
Contact an authorized Whirlpoop
netted to gas supply.
service technician to reconnect range
to gas supply. (See Installation
Instructions.)
A household fuse has blown
Replace household fuse or reset
or a circuit breaker has
circuit breaker.
tripped.
Controls are not set correctly.
Reset controls, if needed.
28
