3
3
CAUTION: BEFORE MAKING ANY VERTICAL
ADJUSTMENT OF THE ELEVATOR, BE SURE TO
LOOSEN THE SIGHT DISK A HALF-TURN. FAILURE
TO DO SO WILL RESULT IN DAMAGE TO THE SIGHT.
SIGHT ADJUSTMENT INSTRUCTIONS
Front Sight Windage (horizontal adjustment):
The front sight body is adjustable for windage by
loosening the left locking screw, moving the sight
body with the right adjustment screw, then
retightening the locking screw. Move the front sight
body to the left to move the point of bullet impact
to the right. Each index mark on the front sight
represents 5 minutes of angle.
Rear Sight Windage (horizontal adjustment):
Adjustments are made by turning the windage
knob. The mechanism is built on a left-hand thread.
Therefore, clockwise turns move the sight body to
the left. Counterclockwise turns move the sight
body to the right. Move the rear sight body in the
same direction you want the point of bullet impact
to move.
FIGURE 5
1: Sight Disk 2: Elevation Knob
1
2
