30 Assembly
15914 (Rev. 5/11/2007)
Wheel Yoke Installation for D80-2 Pull-Type
Cutter
The wheel yoke for use with pneumatic tires is illus-
trated. The spring-loaded wheel yoke installs the same.
Attach wheel yoke (6) to rear of cutter frame with clevis
pins (15) and cotter pins (3) at two points.
Insert crank (11) through pivot block (10). Slide sleeve
(7) onto crank, align hole in sleeve and hole in crank,
and drive the spirol pin (8) into the assembly to attach.
Thread pivot nut (2) onto crank (11) until it will install
into pivot lug (1), then attach with cotter pin (3). Install
spirol pin (4) into crank (11) to prevent crank detach-
ment.
Attach axle with rim (12) and tire (not supplied) to
wheel yoke using lock washer (13) and nut (14).
NOTICE
■ You must use the pneumatic tire with this
wheel yoke. The solid tire may be used with the
spring-loaded wheel yoke.
Figure 23. Wheel Yoke Installation
1. Pivot lug
2. Pivot nut
3. 1/4 x 1-1/2" Cotter pin
4. 1/4 x 1" Spirol pin
5. Grease fitting
6. Wheel yoke
7. Sleeve
8. 5/16 x 1-3/4" Spirol pin
9. Thrust bearing
10. Pivot block
11. Crank
12. Rim (tire not supplied)
13. 1" Standard lock washer
14. 1" Nut
15. 1 x 2-1/2" Clevis pin
