Operation 17
MAN0390 (Rev. 6/30/2006)
Figure 7. Drive Halves Placed Parallel
4. Measure from end of the upper shield to the base
of the bell on the lower shield (A). Add 1-9/16" to
dimension (A). See Figure 8.
Figure 8. Determine Shield Length
5. Cut the shield to the overall dimension.
Figure 9. Cut Shield
6. Place the cutoff portion of the shield against the
end of the shaft and use as a guide. Mark and cut
the shaft.
Figure 10. Cut Shaft to Length
7. Repeat step 6 for the other half of the drive.
8. File and clean cut ends of both drive halves.
Do not use tractor if proper driveline engagement can-
not be obtained through these methods.
Connect driveline to tractor PTO shaft, making sure the
spring-activated locking collar slides freely and locks
driveline to PTO shaft.
NOTICE
■ If attaching with quick hitch the distance
between the tractor PTO and gearbox input shaft
will increase. Please follow the steps as you would
for a 3-point hitch to insure proper engagement.
DRIVELINE INTERFERENCE CHECK
1. Check for clearance between driveline and cutter
deck.
2. Slowly lift cutter and observe driveline. If clearance
between driveline and cutter deck is less than 1
inch, shorten top link or limit upper travel of lower
hitch arms. Refer to tractor operator's manual for
instructions.
CUTTING HEIGHT ADJUSTMENT
On pull-type units with optional hydraulic cut-
ting height adjustment, use a single-acting cylinder
with a maximum extended length of 28-1/4" (718
mm) from attaching point center to center.
Cutting height range is from 2" to 15". A hydraulic cylin-
der or ratchet jack is available for cutting height adjust-
(Rev. 2/6/2009)
