Owner Service 19
29977 (Rev. 1/23/2009)
Figure 5. Slip Clutch Adjustment
CHAIN SHIELDING REPAIR
Inspect chain shielding frequently. Replace any broken
or missing chains as required.
CLEANING
After Each Use
● Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Inspect machine and replace worn or damaged
parts.
● Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
● Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Remove the remainder using a low-pressure water
spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
● Inspect machine and replace worn or damaged
parts.
● Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
● Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
1. Clutch
2. Yoke & square shaft
3. Clutch back-up plate
4. Clutch back-up plate
5. Friction disc
6. Yoke & plate asy
7. Bushing
8. Clutch hub w/bushing
9. Compression spring
10. Flange lock nut
11. Bolt
12. Lock nut
13. Sleeve
14. Bolt
15. Nut
16. 5/8 NC x 3-1/2 Bolt
