A SERVICE OF

logo

Open as PDF
next previous
7
Figure 5 – Interfacing STATUS connection of WL85 with Zone STATUS
line on ZPR68-10
8
In Single Zone systems, the Status LED could show the ON/OFF status of
an AV Receiver. To achieve this, simply plug a 12vDC adapter, such as the
Xantech 781ERGPS Power Supply, into the switched AC Outlet of the AV
Receiver. The 12v ‘+’ and ‘-’ leads are then connected between the
STATUS (‘+’ lead) and GND (‘-’ lead) terminals of the WL85. The
Connecting Block makes a convenient tie-line for extending leads of the
Power Supply to the actual terminals of the WL85 as shown in Figure 6.
Figure 6 – Interfacing STATUS connection of WL85 to Switched Outlet
of AV Receiver
+12VDC
STATUS
GND
IROUT
WL
IR RECEIVER
XANTECH CORP.
To 120VAC
(unswitched)
781ERGPS
789-44
ConnectingBlock
Emitter
Hand Held
Remote
DVD
.
–
+
12VDC
+12VDC
GND
STATUS
IR IN
EMITTERS
IR
RCVR
789-44
CONNECTING BLOCK
®
Emitter
Emitter
WL Series
J-Box
IR Receiver
(rear view)
REMOTE ROOM
MAIN ROOM
Add resistor in series
with STATS line to
adjust brightness, if desired.
(see text, next page)
4- conductor
inter-room cable
(unshielded OK)
Satellite Receiver
A/V Receiver
Plug into
Switched AC Outlet
on A/V Receier
(see text)
786-00
Power supply
(12V at 10mA)
White Striped Side ("+")
+12V
STATUS
GND
IR OUT