12/16 XT1
Examples:
01_10_1_1 Instruct Zone 1 T118 to power off
01_10_1_2 Instruct Zone 1 T118 to power on
01_10_1_3 Instruct zone 1 T118 to power on if it is off, or power off if it is on
12_10_3_21 Zone 12 T118 to tune into preset #21
03_10_4_107_50 Zone 3 T118 to tune to FM 107.50 MHZ
03_10_4_99_55 Zone 3 T118 to tune to FM 99.55 MHZ
(The 2nd digit after the decimal is 50K/step tuning for Europe)
03_10_2_1 Switch band to AM reception
03_10_4_05_80 Zone 3 T118 to tune to AM 580 KHZ
03_10_4_10_30 Zone 3 T118 to tune to AM 1030 KHZ
01_10_6_2 RDS information is fed to third party device continuously
01_10_8_0 Zone 1 T118 to empty the preset currently displaying
01_10_8_15 Zone 1 T118 to write the displayed frequency into preset 15
02_10_11_1 When in FM 100.05 MHZ, Zone 2 T118 outputs FM10005 in ASCII string
02_10_11_5 When in FM 100.05 MHZ, Zone 2 T118 outputs a complete set of operating data
IZONE 05IITID 55IIFM10005IIPRESET 02IITUNING AUTOIIMODE STEREOIIZONE 02IIIR
1IIPOWER ONI
02_10_11_2 Simply output "21" in ASCII if the current preset listening is 21
00_10_15_888_12 Program T118 Zone ID TO 12
00_10_15_222 Read Zone ID
Notes for Programming:
Each time after sending a command to operate a T118, always pause for 0.5 sec then send
command 11 to receive the update data feedbacks from the T118.
Pin Layout
RJ45 DB9-Male DB9-Female
Circuit Item
Pin 1 3 2
TX
Pin 2 2 3
RX
Pin 4 5 5
GND
CN12
5
9
4
8
3
7
2
6
1
10
RX
TX
