Malfunction Possible cause Remedy
The wine is too warm.
Temperature is not properly adjusted. Please look in the “Use” section.
Door was open for an extended
period.
Open the door only as long as necessary.
The appliance is near a heatsource. Please look in the “Installation” section.
Heavy build up of the
frost, possibly also on
the door seal.
Door seal is not air tight (possibly
after changing over the hinges).
Carefully warm the leaking sections of the door
seal with a hair dryer (not hotter than approx.
50 °C). At the same time shape the warmed door
seal by hand such that it sits correctly.
Unusual noises.
Appliance is not level. Readjust the feet.
The appliance is touching thewall or
other objects.
Move the appliance slightly.
A component, e.g. a pipe, on rear
of the appliance is touching another
part of the appliance or the wall.
If necessary, carefully bend the component out
of the way.
The compressor does
not start immediately
after changing the
temperature setting.
This is normal, no error has
occurred.
The compressor starts after a period of time.
Water on the floor. Water drain hole is blocked. See the “Cleaning” section.
What to do if...
Warning: Before troubleshooting, disconnect
the power supply. Only a qualified electrician of
competent person must do the troubleshooting that
is not in this manual.
Important: There are some sounds during normal
use (compressor, refrigerant circulation).
