A SERVICE OF

logo

18
Check the position again by slackening the screws
and pins then, once the best position has been
obtained, fully tighten all the fixings. Cover the visible
part of the top bracket on the panel with plastic cover
(D), inserting it in the locations provided in the
bracket.
Once the door has ben correctly aligned, tighten the
holding nuts on the fixing brackets and attach the
appliance to the adjacent units and the bottom of the
work surface.
For a correct installation operation if the base plate is
more than 100 mm (for cavity height 820 mm) or
more than 150 mm (for cavity height 870 mm) you
must cut out the plate as shown in the diagram.
D472
D
D517
450
D593