GB-6
BCZ3200DL / BCZ3200DW
BEFORE STARTING
THE ENGINE
1.
The area within a perimeter of
15 m (50 ft) of the person using
the product should be considered
a hazardous area into which no
one should enter. If necessary,
yellow warning rope, warning
signs should be placed around the
perimeter of the area. When work
is to be performed simultaneously
by two or more persons, care
should also be taken to constantly
look around or otherwise check for
the presence and locations of
other people working so as to
maintain a distance between each
person sufficient to ensure safety.
2.
Check the condition of working area
to avoid any accident by hitting hid-
den obstacles such as stumps,
stones, cans, or broken glass.
IMPORTANT
Remove any obstacle before begin-
ning work.
3. I
nspect the entire unit for loose fas-
teners and fuel leakage. Make sure
that the cutting attachment is prop-
erly installed and securely fastened.
4.
Be sure to attach the cutting at-
tachment guard securely in place,
or you may get serious injury.
5. Always use the shoulder strap.
Adjust the strap for comfort be-
fore starting the engine. The strap
should be adjusted so the left
hand can comfortably hold the
handlebar grip approximately
waist high.
STARTING THE ENGINE
1.
Keep bystanders and animals at
least 15 m (50 ft) away from the op-
erating point. If you are approached,
immediately stop the engine.
2.
The product is equipped with a
centrifugal clutch mechanism, so
the cutting attachment begins to
rotate as soon as the engine is
started by putting the throttle into
the start position. When starting the
engine, place the product onto the
ground in a flat clear area and hold
it firmly in place so as to ensure that
neither the cutting part nor the
throttle come into contact with any
obstacle when the engine starts.
WARNING
Never place the throttle into the
high-speed position when starting
the engine.
3. After starting the engine, check
to make sure that the cutting at-
tachment stops rotating when the
throttle is moved fully back to its
original position. If it continues to
rotate even after the throttle has
been moved fully back, turn off
the engine and take the unit to
your authorized ZENOAH servic-
ing dealer for repair.
USING THE PRODUCT
IMPORTANT
Cut only materials recommended by
the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both
hands using your whole hand.
Place your feet slightly apart
(slightly further apart than the
width of your shoulders) so that
your weight is distributed evenly
across both legs, and always be
sure to maintain a steady, even
posture while working.
2. Keep cutting attachment below
waist level.
3. Maintain the speed of the engine
at the level required to perform
cutting work, and never raise the
speed of the engine above the
level necessary.
4. If the unit starts to shake or vi-
brate, turn off the engine and
check the whole unit. Do not use
it until the trouble has been prop-
erly corrected.
5. Keep all parts of your body away
from rotating cutting attachment
and hot surfaces.
6. Never touch the muffler, spark
plug, or other metallic parts of the
engine while the engine is in op
eration or immediately after shut-
ting down the engine. Doing so
could result in serious burns or
electrical shock.
5. For safe operation
