Chapter 40 Access Control
XGS-4728F User’s Guide
347
40.3.6 Setting Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the
Switch via web configurator at any one time.
• An administrator is someone who can both view and configure Switch changes.
The username for the Administrator is always admin. The default administrator
password is 1234.
Note: It is highly recommended that you change the default administrator password
(1234).
• A non-administrator (username is something other than admin) is someone
who can view but not configure Switch settings.
Click Management > Access Control > Logins to view the screen as shown.
Figure 207 Management > Access Control > Logins
Options Select the individual SNMP traps that the Switch is to send to the SNMP
station. See Section 40.3.3 on page 340 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically
selects all of the category’s traps. Clear the check boxes for individual
traps that you do not want the Switch to send to the SNMP station.
Clearing a category’s check box automatically clears all of the category’s
trap check boxes (the Switch only sends traps from selected categories).
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 130 Management > Access Control > SNMP > Trap Group (continued)
LABEL DESCRIPTION
