A SERVICE OF

logo

3 - 34 Ethernet RMON MultiProbe Module Installation and Operation Guide
Table 3-9 describes the positions of the DIP switches required to configure
and enable the RMON MultiProbe Module interfaces to corresponding
Ethernet networks. As the table shows, switches 1, 2, 6, 7, and 8 are not
used.
Table 3-9. Network Selection DIP Switch Settings
Switch
Setting
Network Selection
ON OFF
1 Reserved
2 Reserved
3 Ethernet 1 Isolated
4 Ethernet 2 Isolated
5 Ethernet 3 Isolated
6 Reserved
7 Reserved
8 Reserved