ATD-8696
4 IN 1 BALL JOINT SERVICE TOOL SET
WARNING: TO HELP PREVENT PERSONAL INJURY
Always wear ANSI approved goggles when using this product. Normal use of this
product is likely to expose the user to dust and/or microscopic particles containing
chemicals known to the State of California to cause cancer, birth defects or other
reproductive harm. Always wear appropriates safety equipment and clothing when
using this product.
Study, understand, and follow all instructions provided with this product.
Before repairing vehicle, block the wheels to prevent the vehicle from moving.
Check the final alignment of the C-frame press and all tooling with components
before exerting pressure to remove or replace a ball joint.
OPERATING INSTRUCTIONS
Brake Anchor Pin Removal and Installation
1. Remove all lock ring retainers from the brake anchor pins.
2. Position the C-frame press over the brake spider as shown in Figure 1.
3. Tighten the forcing screw until the anchor pin is removed.
"U"Joint Assembly And Disassembly
The basic C-frame press is used to service the "U" joints on most cars and light
trucks.
The "U" joints can be serviced either on or off the vehicle.
