A SERVICE OF

logo

refer to Figure 3.
2. Tighten the forcing screw until the receiving tube contacts the control arm. Check the
alignment of all tooling and components, and continue tightening the forcing screw
until the ball joint is removed.
Installation
1. Clean the control arm and coat the I.D. with a suitable lubricant.
2. Insert the replacement ball joint as straight as possible into the vehicle control arm.
3. Assemble the ball joint press component as shown in Figure 4. Position the receiving
tube, and tighten the forcing screw. Check the alignment of all tooling and
components, and continue tightening the forcing screw until the ball joint is firmly
seated.