Contents
Issue 1 September 1995 vii
Power up AC-Powered Switch 7-3
Power up DC-Powered Switch 7-3
Verify Messages on Terminal 7-3
■ Introduction to Terminal Screens and Commands 7-4
Screens 7-4
Commands 7-5
Getting Help 7-5
■ Log in to the System 7-5
■ Set Required Country Options 7-6
■ Change Craft Password 7-9
■ Set Date and Time 7-11
■ Set System Maintenance Parameters 7-14
■ Save Translations 7-15
Logoff 7-17
8 Test the System 8-1
■ Check the System Status for Each Cabinet 8-1
■ Check Circuit Pack Configuration 8-4
■ Test Time Division Multiplexor (TDM)
Bus in Processor Port Network (PPN) 8-9
■ Test Tone-Clock Boards 8-10
■ Test Switch Processing Element (SPE)
Duplication Memory Shadowing Link 8-11
■ Test Duplicated Switch Processing
Element (SPE) Interchange 8-12
■ Test Expansion Interface Boards 8-14
■ Test Time Division Multiplexer (TDM)
for each Expansion Port Network (EPN) 8-15
■ Test Tone-Clock for each Expansion
Port Network (EPN) 8-16
■ Test Tone-Clock Interchange for each
Expansion Port Network (EPN) 8-17
■ Test Expansion Interface Exchange for
Each Expansion Port Network (EPN) 8-17
■ Check Circuit Pack Configuration Again 8-19
■ Save Translations, if Required 8-20
