SERVSELECT IP VM INSTALLER/USER GUIDE
44
Enable Debug Messages
This menu option turns on console status messages. Because this can significantly reduce
performance, you should only enable debug messages when instructed to do so by
technical support. When you are finished viewing the messages, press any key to exit this
mode.
Set/Change Password
The ServSelect IP VM switch can be set to a secure mode where the Terminal
Applications menu cannot be accessed without first entering a password.
To activate security:
1. Select the Set/Change Password menu option. You will be prompted to decide if you
wish to continue. Enter a Y.
2. Type a password for this switch and press Enter. This password may be up to 14
characters long.
3. You will be prompted to re-type the password. Once you complete this step, security
will be active and you will not be able to access ServSelect IP VM switch terminal
operations without the password.
To change the password:
1. Select the Set/Change Password menu option.
2. You will be prompted to type the old password and a new one.
3. Re-enter the new password to verify.
CAUTION:
This password places your or ServSelect IP VM switch terminal in a secure mode. This password should
be guarded like any network password and care should be taken to avoid forgetting or misplacing it. In the
event that you forgot the password, type Help. You will be given a one time use key to supply to technical
support, who will then supply you with a one time use password that you can use to access the Serial
Port..
Restore Factory Defaults
This menu option will restore all appliance options to the default settings.
Reset Appliance
You can use this menu option to initiate a soft reset of the appliance.
Exit
This menu selection will return you to the ready prompt.
