41
Meat patties not
returning
❏ Check that patties have not gotten stuck on
the return slide
__ Remove awnings to check
__ Remove product from return slide if
necessary
__ Proper cleaning of return slide is
needed daily to remove buildup which
can cause patties to stick
❏ Check return chain to see if patties
are stuck in chain
__ Remove product, then check to make
sure the broiler has been assembled
properly (Awnings, return slide and
stripper blades)
Temperature on
display reads “OPEN”
❏ Inspect wire leads coming out of
temperature probe
__ Remove side panel located above
thermocouple
__ If wire is cut or exposed (insulation),
call service
Computer control
freezes or locks up
(screen doesn’t
change when you
press a button
❏ Reset
__ Turn main power switch off
__ Push and hold red pilot button on
main and flex chambers to relight
__ Turn on again; burners should relight
automatically. If not, follow lighting
procedure
Too much smoke/heat
in the kitchen
❏ Check that hood and fan are working
correctly
❏ Check that broiler is properly positioned
under the hood; check all sides of broiler
❏ Check condition of catalyst (after broiler is
turned off and cooled at end of night) clean if
necessary
❏ Check condition and placement of grease
extractors; clean daily and position properly
Grease on floor from
discharge end
❏ Check that grease troughs are facing into
the grease bucket
Problem Solution
Nieco Corporation - Model 9025
