11
Model Type
40RU = Carrier Fan Coil
Puronr R–410ARefrigerant
Type of Coil
Q = Heat Pump
A = StandardDXCoil
S = Chilled Water Coil
Refrigerant Options
A = None
Nominal Tonnage
25 = 20 Tons
28 = 25 Tons
30 = 30 Tons
Not Used
A=PlaceHolder
Indoor Fan Options
1 = Fan Drive and Motor - Low / Motor Efficiency - Standard
2 = Fan Drive and Motor - Med / Motor Efficiency - Standard
3 = Fan Drive and Motor - High / Motor Efficiency - Standard
Coil Options
A=Al/Cu
Voltage
1 = 575/3/60
5 = 208/230/3/60
6 = 460/3/60
Design Rev
– = Catalog Model Number
1 = Design Revision (original)
Not Used
0=PlaceHolder
Not Used
A=PlaceHolder
Service Options
0 = Non-Painted Cabinet
1 = Painted Cabinet
Not Used
A=PlaceHolder
Brand / Packaging
0=Standard
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
40RUAA25A1A6–0A0A0
_____________ ____
C!0724
Fig. 3 -- Model Number Nomenclature
SETANGISEDNOITISOP
)radnelac lacsif( erutcafunam fo keeW1−2
)ASU ,saxeT ,PTE = G( noitacol gnirutcafunaM5
rebmun laitneuqeS6−10
12345678910
2610G12345
POSITION NUMBER
TYPICAL
Year of manufacture (“10” = 2010)3−4
C!0725
Fig. 4 -- Serial Number Nomenclature
TXV COIL
REMOVE FOAM BLOCK
LEGEND
TXV — Thermostatic Expansion Valve
C10683
Fig. 5 -- Foam Block Location
Unit Positioning -- The unit can be mounted on the floor
for vertical application with return air entering the face of
the unit and supply air discharging vertically through the
top of the unit. The unit can also be applied in a
horizontal arrangement with return air entering
horizontally and the supply air discharging horizontally.
When applying the unit in a horizontal arrangement,
ensure the condensate drain pan is located at the bottom
center of the unit for adequate condensate disposal. See
Fig. 6 for condensate connections for each unit position.
LEGEND
Accessory Line
Alternate Air Intake and Discharge
Air Intake and Discharge
Note: Maintain recommended clearances
per Fig. 1 and Fig. 2
PLUG
PLUG
CONDENSATE
DRAIN
C10684
Fig. 6 -- Typical Unit Positioning
40RU
