2001/2002-2
GENERAL GUIDE
Note
• The display is illuminated for
about three seconds whenever
you enter the Player Mode.
• The display may illuminate for
about three seconds when you
perform a play, stop, or other
operation in the Player Mode.
Switching the Screen between the Current Time and Date
Holding down the
button in the Timekeeping Mode displays
the current date.
Timekeeping Mode Alarm Mode Stopwatch Mode Setting Mode
Press MODE.
Hold down MODE. Hold down MODE.
Day of the week
Month Day Year
10 588
35
12 00
10 58
35
Player Mode
01 2
36
63
00
▲
▲
▲
▲
▲
▲
• Press MODE to change from mode to mode.
• Pressing the
button in any mode besides the Player Mode illuminates
the display.
• Pressing the MODE button after you perform an operation in the Alarm
Mode, Stopwatch Mode, or Setting Mode returns directly to the
Timekeeping Mode.
• The watch reverts to the Timekeeping Mode automatically if you do not
perform any button operation in any mode for about one minute.
GETTING READY
Unpacking
Make sure all of the items shown on this page are included when you unpack
your watch.
Interface/Charger Unit AC Adaptor
Stereo Earphones Earphone Attachment
USB Cable CD-ROM
(Link Soft)
Connecting the Stereo Earphones to the Watch
You must use the earphone attachment to connect the stereo earphones to
the watch.
To attach the earphone attachment to the watch
1. First plug the earphone plug into the jack on the bottom of the earphone
attachment.
2. Hook the earphone attachment’s lower hook into the hole on the side of
the watch, and then swing the top of the attachment against the watch so
the upper hook locks on to the watch.
➔
To remove the earphone attachment from the watch
Press the release button at the top of the earphone attachment to release it
from the watch.
Important!
• The watch is not water resistant while the
earphone attachment is attached. Avoid all
moisture whenever the earphone
attachment is attached to the watch.
• We recommend that you do not leave the
earphone attachment attached to the watch
when you are not using it.
• Make sure that the attachment
hooks do not accidentally press
the reset button.
• Press the attachment against
the watch until it clicks into
place.
