Setup
OVATION™ E-190WW User Manual Rev. 3 -7-
The OVATION™ E-190WW supports power linking. You can power link up to 4 units on
120 V; up to 7 units on 208 V; or up to 8 units on 230 V.
This product comes with a Neutrik® powerCON® input power
cord. This product does not
come with a power linking cable; however, a power linking cable is available as an option.
You can link the OVATION™ E-190WW to a DMX controller using a standard DMX
serial connection. If using other DMX-compatible products with the OVATION™ E-
190WW, you can control each individually with a single DMX controller.
The OVATION™ E-190WW uses the standard DMX data connection for the 1-, 2- and
3-channel DMX modes.
· Refer to the Introduction chapter for a brief description of these modes.
· Refer to the Operation chapter to learn how to configure the OVATION™ E-190WW
to work in these modes.
· The DMX Values section provides you with detailed information regarding the DMX
Connectivity
The Master/Slave mode allows a single OVATION™ E-190WW (the “master”) to control
the actions of one or more OVATION™ E-190WW units (the “slaves”) without
of a DMX controller to control the slaves. Once set and connected, the slaves
operate in unison with the master. For instructions on connecting and configuring t
product, see Master/Slave Mode.
DO NOT connect a DMX controller to products operating in Slave mode. The DMX
controller signals may interfere with the signals from the master product.
The Operation section of this manual provides detailed instructions on how to
configure the master and slaves.
If you are not familiar with or need more information about DMX standards,
master/s
lave connectivity, or the DMX cables needed to link this product to a DMX
controller, download the DMX Primer
from the CHAUVET® website:
www.chauvetpro.com.
