SlimBANK™ TRI-18 User Manual Page 15 of 19
To select a preset static color, do the following:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER> and r (red), g (green), b (blue), gb (cyan), r b (magenta),
rg (yellow), or rgb (white) shows on the display.
3. Use <UP> or <DOWN> to select the desired preset color.
4. Press <ENTER>.
Mixing
To custom mix a color, follow the instructions below:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> and one of the following colors shows on the display: rXXX (red),
gXXX (green), or bXXX (blue).
3. Press <ENTER> repeatedly to select the desired color.
4. Use <UP> or <DOWN> to select the desired color value 0–255 (0 to 100%).
NOTE: Selecting 0 will turn the color off.
5. Press <ENTER> to set the color value and continue to the next color.
6. Repeat steps 3 to 5 until you create your desired color.
Dimmer Mode
To select the dimmer mode, do the following:
Press <MENU> repeatedly until dIM shows on the display. 1.
Press <ENTER> and one of the following shows on the display: 2.
· OFF (dimmer speed off)
· dIM1 (dimmer mode 1, fast speed)
· dIM2 (dimmer mode 2, middle speed)
· dIM3 (dimmer mode 3, slow speed)
Use <UP> or <DOWN> to select the desired dimmer mode. 3.
Press <ENTER>. 4.
Display
To view the temperature of the LEDs, follow the instructions below:
1. Press <MENU> repeatedly until tEMP shows on the display.
2. Press <ENTER> and the temperature will be shown in degrees Celsius.
