Appendix A
Compaq
(90)Start of CMOS test .
Chips & Tech (90)Set-up RAM.
Phoenix
AMI
(90)Initialize hard-disk controller.(Beep)=3-2-1-1
Error Code - 91
(91)Floppy setup complete. Hard disk setup to be done next.
Chips & Tech (91)CPU speed.
Phoenix
AMI
(91)Initialize local-bus hard-disk controller.(Beep)=3-2-1-2
Error Code - 92
(92)Hard disk setup complete. About to go for BIOS ROM data area check. (92)Error
Chips & Tech (92)Configuration check.
Phoenix
AMI
Compaq
Phoenix
ACER
AMI
(92)Jump to User Patch 2.(Beep)= 3-2-1-3
Error Code - 93
(93)BIOS ROM data area check halfway. BIOS ROM data area check to be
completed.
(93)Start of DMA controller test.
(93)Build MPTABLE for multi processor boards.
Error Code - 94
(94)#5 shutdown.
(94)Hard disk setup complete. Going to set base and extended memory size. BIOS
ROM data area check over.
(94)Page registers seem OK.
Chips & Tech (94)POD Bootstrap.
Phoenix
AMI
(94)Disable A20 address line.(Beep)=3-2-2-1
Error Code - 95
(95)Memory size adjusted due to mouse support, hard disk type-47.Going to verify
from display memory.
Chips & Tech (95)Reset ICS.
Phoenix (95)Install CD ROM for boot.
AMI
Compaq
(96)Memory size adjusted due to mouse support, hard disk type-47.Going to do any
Init before C800 optical ROM control. Returned after verifying from display
memory.
(96)8237 DMA Initialization complete.
Chips & Tech (96)BIOS PEAK.
Phoenix
(96)Clear huge ES segment register.(Beep)=3-2-2-3.
Error Code - 97
(97)Any Init before C800 optional ROM control is over. Optional ROM check &
control will be done next.
Chips & Tech (97)VGA power.
up Multi Processor table.
ACER (98)#A shutdown.
AMI
(98)Optional ROM control is done. About to give control to do any required
processing after optional ROM returns control.
Chips & Tech (98)Adapters POS.
Phoenix (98)Search for option ROMs. One long, two short beeps on checksum
failure.(Beep)=3-2-3-1.
AMI
Phoenix
AMI
Phoenix
AMI
ACER
AMI
Phoenix
(99)Any initialization required after optional ROM test over. Going to setup timer
data area and printer base address.
(99)Check for SMART Drive(optional).
Error Code - 9A
(9A)Return after setting timer and printer base address. Going to set the RS-232
base address.
(9A)Shadow option ROMS.(Beep)=3-2-3-3.
Error Code - 9B
232 base address. Going to de any initialization before
Co-Processor test.
(9C)Required initialization before co-Processor is over. Going to initialize the
CoProcessor next.
(9C)Set up Power Management.(Beep)=3-2-4-1.
Error Code - 9D
(9D)CoProcessor initialized. Going to do any initialization after CoProcessor test.
Error Code - 9E
20
