How "To Use Your Pressure Washer
On the end of your spray gun wand is a quick connect
body. Mounted to your pressure washer handle are five
quick connect nozzles.,
ou,=. .ozzLE\., 1
To achieve desired spray pattern, insertone of the five
quick connect nozzles. Start by pulling the quick connect
sleeve back and then insert the desired nozzle tip,,Then
press down on the nozzle tip to insure that it is in the
locked position and ready to use.
IMPORTANT: When switching out tips, be sure the gun
trigger isin the locked position and engine is turned off.
Each nozzle tip will give you a varying degree of spray
= White
° Green
- Yellow
- Red
Soap nozzle; used when wanting to draw
chemical
40° spray pattern
- 25° spray pattern
- 15° spray paten
- 0° spray pattern
IMPORTANT; If you get spray nozzle too close,
especially on high pressure, you may damage the
oiean{ng surface.
= The pressure control knob is located on the pump.
You can increase the pressure by turning the knob
clockwise or decrease the pressure by turning the
knob counterclockwise.
PRESSURE
CONTROL
KNOB
NOTE." 'The unit is set at its maximum pressure at the
factory,, Do not attempt to adjust the pressure higher
than this factory setting.
° Prepare the soap/chemical as required by your job,
• Insert soap/chemical llne into your container (soap/
chemicals not included)_
NOTE: The first step involves applying an appropriate
soap/them]ca! soh_tion to penetrate and loosen grime.
The soap/chemical {sapplied at low pressure to avoid
splashing, over spray and waste., Leave the solution
on surface for 3 to 5 minutes to allow solution to work.
NOTE: The second step involves clean)rig the surface
you have prepared with the pressure washer and then
rinsing it clean
- Turn the adjustable nozzle counter clockwise to _ow
pressure mode, Soap/chemicals cannot be applied
with nozzle in high pressure position.
• Revlew the use of the adjustable nozzle.
Connect garden hose to water inlet (see "To Start Your
Pressure Washer*'), check that high pressure hose is
connected to spray gun and pump (see Assembly),
and start engine.
, Apply soap/chemicals to dry surface, starting from the
bottom and working up,
- A{Iow the soap/chemicals to soak in between 3-5
minutes before washlng and dnsing,
. For cleaning, start at lower portion of area to be
washed and work upward, using long, even over,.,
lapping strokes°
Your pressure washer ls equipped with a chemical
injector adjustment knob. With the knob fully opened
you wit! get maximum chemical draw. With knob fully
closed you will get no chemica] drawn Turn knob in
counter clockwise direction to achieve more chemical
draw and clockwise for _esschemical draw,
O
Using Soaps/Chemicals
,.IMPORTANT: Use soaps and chemicals that are
designed specifically for use with pressure washers. To
apply soap/chemicals follow these steps:
- After using the pressure washer, it Is recommended
the pump, chemical injector and chemical line be
flushed with clear water. To do so, simply place
chemical injector hose inwater and siphon for 1 to 2
minutes.
1t
