Using the System Setup Program | 125
Enables booting to legacy mode, ensures compatibility
with operating systems that do not support UEFI.
All four cores of the processor are enabled. This is
applicable for Quad-core processor only.
Two cores of the processor are enabled. This is applicable
for Quad-core and Dual-core processors.
Single core of the processor is enabled. This is applicable
for Quad-core and Dual-Core processors.
Sets to enable (default), the processor can operate in all
available Power C States.
Sets to disable, there are no C states available for the
processor.
Enables the BIOS from prompting for F1/F2 on error.
BIOS pauses at F1/F2 prompt.
Disables the BIOS from prompting for F1/F2 on error.
BIOS pauses at F1/F2 prompt
Enables the display of the splash or summary screen,
rather than the detail of the POST flow.
Disables the display of the splash or summary screen. The
user is able to see the detail of the POST messages.
The first NIC is used for PXE boot, followed by NIC2.
The second NIC is used for PXE boot, followed by NIC1.
By default, set rear serial port address as 0x3F8 and
internal serial port address as 0x2F8.
Set rear serial port address as 0x2F8 and internal serial
port address as 0x3F8.
Memory Operating Mode set to support Optimizer.
Memory Operating Mode set to support Sparing.
