462 Configuring Quality of Service
www.dell.com | support.dell.com
Figure 10-18. QoS Policy Binding Page
Interface
— Selects an interface.
Attach Policy to Interface
— The policy implemented on the interface.
NOTE: A policy map that contains a set or trust policy-map class configuration command, or that has an
ACL classification cannot be attached to an egress interface.
Attaching a Policy to an Interface
1
Open the
QoS Policy Binding
page.
2
Select an interface type.
Only one policy map per interface per direction is supported. However, the same policy map
can be applied to multiple interfaces and directions.
3
Select the port, LAG, or VLAN number from the appropriate drop-down menu.
4
Select a policy from the
Attach Policy to Interface
drop-down menu.
5
Click
Apply Changes
.
The selected policy is implemented on the selected interface, and the device is updated.
Removing Policies from Interfaces
1
Open the
QoS Policy Binding
page.
2
Click
Show All
to display the
PTI Reference Table
page.
