21
EN
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK! • The water tank is empty or
positioned incorrectly.
• Fill the tank with water
and/or insert it correctly,
pushing it as far as it will go
until it clicks into place.
GROUND TOO FINE ADJUST
MILL!
Insert water spout and press
ok
• The grinding is too fine and
the coffee runs off too
slowly.
• The machine is not able to
make coffee.
• Turn the grinding adjust-
ment knob one click
towards the 7.
• Insert the hot water spout,
press the button and
run off water from the
spout for a few seconds
INSERT WATER SPOUT!
• The water spout is not
inserted or is inserted
incorrectly.
• Insert the hot water spout.
EMPTY GROUNDS CONTAINER • The grounds container (A9)
is full.
• Empty the grounds contai-
ner and clean, then replace.
Important: when removing
the drip tray, the grounds
container MUST be emp-
tied, even if it is not com-
pletely full. If this is not
done, when you make the
next coffees, the grounds
container may fill up more
than expected and clog the
machine.
INSERT GROUNDS CONTAI-
NER
• After cleaning, the grounds
container has not been
replaced.
• Open the service door and
insert the grounds contai-
ner.
INSERT MILK CONTAINER! • The milk container is not
inserted.
• Insert milk container.
ADD PRE-GROUND COFFEE!
• The "pre-ground coffee"
function has been selected
without placing any pre-
ground coffee in the funnel.
• Add the pre-ground coffee
to the funnel or select the
"coffee beans" function.
