Producing hot water
1. Switch the machine on by turning the selector dial
to the position (the relative light comes on) (g.
4). Wait for the OK light to switch on (g. 7).
2. Position a container under the cappuccino nozzle.
3. When the OK light comes on, turn the selector dial
to the
position (g. 8) and turn the steam dial
anti-clockwise at the same time (g. 16). The hot
water will be delivered from the cappuccino nozzle.
4. To interrupt the hot water, turn the steam dial
clockwise and turn the selector dial to the
position.
Cleaning
Danger!
in water. It is an electrical appliance.
external parts of the appliance, switch the machine
o, remove the plug from the socket and let the
machine cool down.
Cleaning and maintenance of the lter
Clean the lter-holder and ground coee lter about
every 300 coees or if the coee drips through the lter-
holder and does not ow unrestricted:
indicated by the arrow on the cap itself.
by pushing it from the cap end.
thoroughly using hot water and a brush (g. 22).
Check that the holes in the metal lter are not
blocked. If this is not the case, clean them using a
pin (see g. 23) or when descaling.
plastic disc pin is inserted inside the hole in the
gasket as indicated by the arrow in (g. 24).
lter (g. 25), making sure that the pin is inserted
into the hole of the support itself (see arrow g.
25).
The warranty is not valid if the cleaning operations
described above are not performed on a regular basis.
Cleaning the boiler outlet
About every 300 coees the espresso boiler outlet must
be cleaned as follows:
the plug is disconnected from the socket;
espresso boiler outlet (g. 26);
brush. Check that the holes are not blocked. If this is
not the case, clean them using a pin (g. 23).
position it correctly on the gasket.
The warranty is not valid if the cleaning operations
described above are not performed on a regular basis.
Other cleaning operations
1. Do not use solvents or abrasive detergents to clean
the machine. Use a soft, damp cloth.
2. Clean the lter-holder cup, the lters, drip tray and
water tank regularly.
To empty the drip tray, remove the cup warmer grid,
remove the water and clean the tray using a cloth:
then re-assemble the drip tray.
Clean the water tank using a soft bottle-brush in
order to reach the bottom.
Danger!
During cleaning, never immerse the machine in water: it
is an electric appliance.
