5-3
16. Press [Enter] to open the selection window.
17. Select “Regular Interval” or “Daily”.
18. Press [Enter] to close the selection window.
19. Press [↓].
` When “Regular Interval” is selected on step 17,
(1) Press [Enter] to open the window for interval time entry.
(2) Key in the interval time at Interval Time.
(3) Press [Enter] to close the window.
(4) Press [↓].
(5) Press [Enter] to open the window for report times entry.
(6) Key in the Report times or select “No limit”.
(7) Press [Enter] to close the window.
` When “Daily” is selected on step 17,
(1) Press [Enter] to open the window for start time entry.
(2) Key in the start time at Start Time 1.
(3) Press [Enter] to close the window.
(4) Press [↓].
(5) If necessary, key in the start time of Start Times 2-4.
20. Press [Esc] to register the above settings.
Position Reports
1. Data Report
2. Message Reports
3. Data Network ID
Data Report
OFF
2
Regular Interval
01:00
24 (---: No Limit)
--:--
--:--
--:--
--:--
Data Report Programming
Status
Report Length
Destination
DNID
LES ID
Member No.
Activation
Interval Time
Report Times
Start Time1
Start Time2
Start Time3
Start Time4
Entry
No
Yes
Figure 5-3 Data report menu
21. Select “Yes”.
22. Press [Enter] to close the Data Report window.
