CHAPTER 17: MISCELLANEOUS COMMANDS MISCELLANEOUS COMMANDS
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 17–19
The Simple Mail Transfer Protocol (SMTP) commands for e-mail are shown below. Refer to
Chapter 17 - E-mail for additional details.
•
add: adds a recipient
•
delete: deletes a recipient
•
help smtp
•
sendmail: sends e-mail
•
server: sets the global SMTP server configuration
•
smtp: enables/disables SMTP e-mail alert
The Simple Network Management Protocol (SNMP) commands are shown below. Refer to
Chapter 16 - SNMP for additional details.
•
authentraps: enable/disables the authentication traps
•
community: configures SNMP community names
•
help snmp
•
mgrip: adds or deletes the SNMP manager IP
•
setvar: configures system name, contact, or location
•
traps: adds or deletes a trap receiver
The Simple Network Time Protocol (SNTP) commands are shown below. Refer to Chapter 5 -
Network Time for additional details.
•
delete: deletes the SNTP server from SNTP server database
•
help sntp
•
setsntp: adds SNTP server into the SNTP server database
•
sntp: configures parameters for SNTP system
•
sync: sets the interval for synchronization time with an NTP server
The Spanning Tree Protocol (STP) commands are shown below. Refer to Chapter 12 -
Spanning Tree Protocol (STP) for additional details.
•
cost
•
lll
•
port
•
priority
•
s-ring
•
stp
•
timers
The user commands are shown below.
•
add: adds a new user
•
chlevel: changes the user access permissions
•
delete: deletes an existing user
•
help user
•
passwd: change the user password
•
tacplus
•
tacserver
•
useraccess
