20
OPERATION
To clean:
• Pour detergent in the detergent tank.
• Install the black soap nozzle on the spray wand.
• Start the pressure washer and spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface.
To rinse:
• Using the 25˚ nozzle, spray away from the rinsing surface for approximately 10 seconds to
allow any remaining detergent to be ushed from the line.
• Start at the top of the area to be rinsed and work down, overlapping the strokes.
MOVING THE PRESSURE WASHER
To move the pressure washer:
• Turn the pressure washer off. Point nozzle in a safe direction and pull trigger to release water
pressure.
• Raise the handle up until the buttons click into the holes on the handle.
• Tilt the machine toward you until it balances on the wheels then roll the machine to the
desired position.
Fig. 10
OPERATING THE PRESSURE WASHER
(See Figure 10.)
Use only detergents designed for pressure washers. Many detergents may require mixing prior
to use. Prepare cleaning solution as instructed on the solution bottle.
