Model H8192 1" Belt/8" Disc Combo Sander
-17-
5. Turn the machine OFF.
6. Remove the switch disabling key, as shown
in Figure 21.
Test Run
Once the assembly is complete, test run your
sander to make sure it runs properly and is ready
for regular operation.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the switch disabling mechanism on the switch
works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration,
stop using the machine immediately, then review
Troubleshooting on Page 24.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the sander:
1. Make sure you have read the safety
instructions at the beginning of the manual
and that the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Connect the machine to the power source.
4. Verify that the machine is operating correctly
by turning the machine
ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7. Flip the toggle switch to the ON position.
—If the machine does not start, the switch
disabling feature is working as designed.
—If the machine starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
8. When the Test Run has been successfully
completed, check the tracking of the sanding
belt and make adjustments if necessary (refer
to Sanding Belt Tracking on Page 22).
Figure 21. Removing disabling key from the
toggle switch.
