Heath Zenith 598-1127-03 Manual

A SERVICE OF

next previous

-2-

598-1127-03

5. Mount push button.Useeitherscrewsordouble

sided tape to mount push button.

• Tomountwithscrews,re-

move back of case by pushing in tab on bottom

withasmallscrewdriver(seeFigure1).Note:

Removematerialinscrewholes(ifneeded)

beforemountingwithscrews.Attachbackof

casetodoorjamborwall(seeFigure4).Snap

front of push button on.

• Tape Mounting:Whenattachingpushbutton

using double sided tape, make sure the surface

ofthedoorjamborwallisclean.

6. Mount chime. Determine mounting location.

• Drill7/32"diameterpilotholeforwallanchor.

• Mountkeyholescrewtowallleavingabout1/8"

(3mm)ofthescrewthreadsexposed.

• Replacecoverontobatterycompartment.

• Usingkeyholeonbackofchimebase,hang

baseonscrew(seeFigure5).

Figure 4

A B C 1 2 3

Figure 5