Heath Zenith 598-1127-03 Manual

A SERVICE OF

next previous

-5-

598-1127-03

3.Tochangethecode,either:

• Addajumpertothesamelocationonboththepushbuttonandthechime

or...

• Removeajumperfromthesamelocationonboththepushbuttonandthe

chime or...

• Moveajumperonthepushbuttonfromonelocationtoanother.Movethe

correspondingjumperonthechimetomatchthenewlocationinthepush

button.

 Example:Movejumperatlocation“1”tolocation“2”onboththepush

button and the chime.

Note:



Note:Unitwillcomefactorysetwithjumpersinlocations1,2,and3onthe

pushbuttonandonthechime(seeFigure7).

Therangeofthewirelesschimecanvarywithlocation,temperature,and

battery condition.

*CodeSettings1-3

Must Match Both Push

ButtonandChime

Inside Push

Button

InsideChime

Note: Some models might require the use

oftweezerstoremoveandreplacethe

jumpers.

Figure 7

123

AB C 1 2 3