22
Combi HP thermostatic mixer shower
FITTING THE TAMPERPROOF FIXED HEAD -
BUILT-IN
FITTING THE TAMPERPROOF FIXED
HEAD
(Built in option only)
Complete outlet pipework from the valve
ending in a ½” BSP female threaded fitting (not
supplied) (fig.59).
Note: The depth of thread on the fixed head
unit from wall surface is 18 mm (fig.60). It is
advisable that pipework installed in solid walls be
provided with enough free play inside a cavity to
allow any slack to be accommodated.
Make good the wall
Screw the fixed head assembly to the female
fitting. Screw tight to the wall and make sure
fixed head is in the correct attitude.
Mark the position of the three fixing holes
(fig.61). Remove the fixed head. Drill and plug
the holes using the plugs supplied.
Screw the fixed head assembly to the female
fitting using PTFE tape to seal the joint. Secure
the fixed head to the wall with the three screws
supplied (fig.62).
Screw on the adjustable showerhead, making
sure the supplied flat sealing washer is in place
(fig.63).
Note: The showerhead must be screwed on
tight in order to make sure of a watertight
connection. Use a suitable tool if necessary.
Using an allen key, lock the showerhead in
position by tightening the grub screw (fig.64).
Fig.59 Fig.60
Fig.61 Fig.62
Fig.63
Fig.64
