12 Quick Reference Service Manual
HP DesignJet 2500CP and 2000CP Printers
D16. Erase EEROM
Purpose Ć To clear the EEROM.
If D1600 OK" Ć EEROM erased correctly.
If D1601 Fail" Ć Replace Electronics Module.
D17. Reset Counters
Purpose Ć To reset the internal counters.
If D1700 OK" Ć Counters reset correctly.
If D1701 Fail" Ć Replace Electronics Module.
D19. Hard Disk Drive Revision
Purpose Ć To show the revision of the internal Hard Disk Drive.
Calibrations
Entering the Service Calibrations Menu System
1 Hold the UP and ENTER keys down and switch printer ON from the power switch on
the back of the printer. Wait until Status/Initializing" is displayed before releasing keys.
2 Once Status/Ready" is displayed, scroll to Utilities / Service Tests / Calibrations and
press Enter button. Use Arrow buttons to scroll through selections and press Enter
button to begin a specific calibration.
Calibrations To Be Done
When Required
C01 C02 C03 C04 C05 C06 C07 C08
Electronics Module is replaced Yes Yes Yes No Yes Yes Yes Yes
Carriage is disassembled or replaced Yes Yes Yes No Yes Yes Yes Yes
Refill Assembly is disassembled or replaced No Yes No No Yes No Yes No
Line Sensor is disassembled or replaced No No Yes No Yes Yes Yes Yes
Service station is disassembled or replaced No No No No No No No No
XĆaxis Assembly is disassembled or replaced No No No No No No No Yes
Drive Roller is disassembled or replaced No No No No No No No Yes
Banding Problem No No Yes No Yes Yes No Yes
Edge Detect Problem No No Yes No No No No No
Misalignment between Colors No No Yes No Yes Yes No Yes
Color Accuracy Problem No No Yes No No No Yes No
Nozzles Out or Misdirected No No No No No Yes No No
