SECTION 4
MAINTENANCE
20
Replacing the Feed Rollers
To replace the feed rollers on the AstroJet printer follow the steps below:
1. Before removing the feed roller access
plate, unplug the power to the printer.
2. Using a Phillips screwdriver, remove the
three screws from the feed roller access
plate.
3. Remove the feed roller access plate.
4. Rotate the feed roller shaft so that the
screws are face up and use a 3/32-inch
Allen wrench to remove the two button
head cap screws. This will permit you to
remove one half of the feed roller. Rotate
the shaft until the two screws holding the
second half of the feed roller in place are
accessible. Remove those screws also.
Install the feed roller half and replace the
screws. Rotate the shaft, replace the second
feed roller half, and fasten with the
remaining screws.
5. Replace the feed roller access plate and
fasten with the four Phillips screws.
