A SERVICE OF

logo

Service Calibrations 4-27
The control panel asks whether to accept the current head
heights.
12. Press
" to save the calibration.
The control panel prompts you to remove the head height
gauge and ensure that the platen is clear of all obstructions.
13. Press ! (Proceed) to return the carriage to its home
position.
14. The control panel prompts you to press ! (Proceed) to
complete the calibration.
15. Press ! (Proceed).
The control panel asks whether you want to perform a media
thickness calibration next (required).
To perform a media thickness sensor calibration, press
". Then go to the next section, “Calibrating the Media
Thickness Sensor” on page 4-28.