CLI commands
snmp-server trap destination
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap destination <host> <[port number]>
Add a new trap destination.
no snmp-server trap destination <host> [<port>]
Deletes the specified trap destination.
Parameters
<host> Sets the IP address or domain name of the host that the AP will send traps
to.
<[port number]> SNMP port number. Range 1 - 65535. By default port 162 is used
snmp-server trap heartbeat
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap heartbeat
Enables sending of heartbeat traps at regular intervals.
no snmp-server trap heartbeat
Disables sending of heartbeat traps at regular intervals.
snmp-server trap link-state
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap link-state
Send a trap when the link state changes on any interface.
no snmp-server trap link-state
Do not send this trap.
snmp-server trap snmp-authentication
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server trap snmp-authentication
Send a trap each time an SNMP request fails to supply the correct community name.
snmp-server version 1
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server version 1
Enable version 1
no snmp-server version 1
Disable version 1
2-22
