Contents
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
xiv
Figures (continued)
Figures (continued)
Figure 2-5. Removing End Piece of Pallet 2-9
Figure 2-6. Velcro Strips on Loading Pallet 2-9
Figure 2-7. Leveling Pads Must Be Raised Before Enclosure Is Moved 2-10
Figure 2-8. Use Two People to Move an Enclosure Stack 2-11
Figure 2-9. Lowering Legs of Base Enclosure 2-12
Figure 2-10. Groundstrap Connector Locations 2-13
Figure 2-11. Groundstrap Connections Between Enclosures 2-14
Figure 2-12. Examples of Groundstrap Locations Between Enclosures 2-15
Figure 2-13. Appearance Side, Processor Enclosure 2-17
Figure 2-14. Service Side: Processor Enclosure Without Power Shelf 2-18
Figure 2-15. Service Side: Processor Enclosure With Power Shelf 2-19
Figure 2-16. Service Side: I/O Enclosure Without Power Shelf 2-20
Figure 2-17. Service Side: I/O Enclosure With Power Shelf 2-21
Figure 2-18. Unlocking and Opening an Enclosure Door 2-22
Figure 2-19. Reseating a Disk Drive 2-23
Figure 2-20. Reseating a PMF CRU or IOMF CRU 2-24
Figure 2-21. Reseating a SEB or MSEB 2-25
Figure 2-22. Reseating a ServerNet Adapter 2-26
Figure 3-1. Connecting and Securing Power-On Cables 3-3
Figure 3-2. EPO Connector on a System Enclosure 3-4
Figure 3-3. Securing ServerNet Cables With Cable Ties 3-6
Figure 4-1. Securing the Frame to the Enclosure Using a Mounting Hole 4-2
Figure 4-2. Inserting a Phillips Screw Into the Mounting Hole 4-2
Figure 4-3. Tightening a Phillips Screw in a Mounting Hole 4-3
Figure 4-4. Service-Side Door Installed on a System Enclosure 4-4
Figure 5-1. Setup Configuration 5-11
Figure 6-1. Processor Enclosure PMF CRU Ethernet Ports 6-3
Figure 6-2. Connections for the Setup Configuration 6-6
Figure 7-1. 5175 Tape Subsystem 7-2
Figure 7-2. Unloading a Tape Subsystem 7-3
Figure 7-3. Removing the Shipping Restraints From a 5175 Tape Subsystem 7-5
Figure 7-4. Installing the Top Panel and Corner Caps on a 5175 Tape
Subsystem 7-6
Figure 7-5. Connecting a SCSI Cable to a 5175 Tape Subsystem 7-7
Figure 7-6. AC Power Switch for 5175 Tape Drive CRU 7-8
Figure 7-7. 519x Tape Subsystem 7-9
Figure 7-8. Connecting a SCSI Cable to a 519x Tape Subsystem 7-10
Figure 8-1. AC Power Switch for 5175 Tape Drive 8-4
