EXCEL 500/600 INSTALLATION INSTRUCTIONS
Excel 500-XCL5010
Plug in the communication module until it snaps into the con-
1. Attach the DIN rail mounting clips to the housing.
troller housing
2. Mount the controller on the DIN rail.
NOTE: If the communication module has been replaced or
pulled out and plugged in again, push the reset
1
7
button after power on.
1
2
3
Fig. 16. Mounting Excel 500-XCL5010 on DIN rail
Excel 500-XCL5010 Communication Module
CAUTION
Always plug in the communication module before
connecting the power supply.
Always disconnect the power supply before
unplugging the communication module.
Installation through a Control Panel Door
(not XCL5010)
IMPORTANT
Observer the minimum spacing of 1.5 in. (35 mm)
when installing more than one housing. Do not ex-
ceed the maximum spacing; otherwise, the tailor-
made internal bus cables will be too short.
1, Prepare the door in accordance with the following.
dimensions.
Fig. 18. Panel door mounting dimensions
2. Insert the housing.
4
Fig. 17. Inserting the communication module
EN1R-1047GE51 R0902 10
Fig. 19. Inserting the housing in the panel door
3. Insert the retaining clamp.
