72 Nortel Networks L2/3 Ethernet Switch Module for IBM Eserver BladeCenter
1003 token-ring-default act/unsup
1004 fddinet-default act/unsup
1005 trnet-default act/unsup
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1 enet 100001 1500 - - - - - 0 0
5 enet 100005 1500 - - - - - 0 0
10 enet 100010 1500 - - - - - 0 0
20 enet 100020 1500 - - - - - 0 0
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
99 enet 100099 1500 - - - - - 0 0
1002 fddi 101002 1500 - - - - - 0 0
1003 tr 101003 1500 - - - - - 0 0
1004 fdnet 101004 1500 - - - ieee - 0 0
1005 trnet 101005 1500 - - - ibm - 0 0
Remote SPAN VLANs
------------------------------------------------------------------------------
Primary Secondary Type Ports
------- --------- ----------------- ------------------------------------------
Example 7-3 creates IP interfaces to be used later.
Example 7-3 Create IP addresses
interface Vlan10
ip address 10.10.0.245 255.255.255.0 ! ip address 10.10.0.246 255.255.255.0
interface Vlan20
ip address 10.20.0.245 255.255.255.0 ! ip address 10.20.0.246 255.255.255.0
interface Vlan99
ip address 10.99.0.245 255.255.255.0 ! ip address 10.99.0.246 255.255.255.0
To start setting up the ports:
1. Access the interface level for g0/1 and g0/2 with the following:
interface range g0/1-2
Note: If there are any unwanted VLANs, you can remove them with the no vlan #
command (where # is the number of the VLAN to remove). The VLAN information is not
included when dumping the switch configuration with the sh run command. VLAN
information is stored separately in a vlan.dat file.
Important: When looking at the configuration commands presented, commands toward
the left margin are for Core1 or GbESM_1 switches. Where the GbESM_2 or Core2 switch
configurations differ, the commands presented within comment syntax (/* for GbESM, !
for Cisco, # for Extreme) are for the counterpart switch of the same type, GbESM_2 or
Core2.
