A SERVICE OF

logo

Open as PDF
next previous
Page 11 of 16 2342-232/2444A2WH4, 2342-432, 2342-532 Rev: 1/21/2014 7:14 AM
Beeper Behavior
Command Method
Beeper Disabled
(Default)
Beeper Enabled
On
Tap
-
Single Beep
Off
Tap
-
Single Beep
Fast-On
Double-Tap
-
Single Beep
Fast-Off
Double-Tap
-
Single Beep
Begin Bright
Press & hold
-
Single Beep
Begin Dim
Press & hold
-
Single Beep
Setup Action
Beeper
Enter Setup Mode, Transition to next setup mode or Exit
Setup Mode
Single Beep
Setup successful, return to Ready Mode
Double-Beep
Return to Ready Mode after a longer than 3 minute time-
out
Long Beep (3 seconds)
Failure to add a scene responder
Long Beep (3 seconds)
Exiting Stuck Button
Long Beep (3 seconds)
LED Behavior During Setup
Mini Remote has a two-color LED (Green & Red) which displays helpful information.
LED State
Meaning
Blinking Green slowly
Add Responder Setup Mode, or
LED on/off Setup Mode
Blinking Red slowly
Remove Responder Setup Mode
Double-Blinking Green slowly
Multi-Add Responder Setup Mode, or
Beeper on/off Setup Mode
Double-Blinking Red slowly
Multi-Remove Responder Setup Mode, or
Keypad Configuration Setup Mode
Factory Reset
The factory reset procedure clears all settings from Mini Remote including INSTEON scenes.
1) If possible, unlink (remove) all scene responders prior to performing factory reset
2) Turn Mini Remote off (slide power switch to left)
3) Press & Hold Set Button
4) While continuing to hold the Set Button, turn Mini Remote back on (slide power switch to the right)
Mini Remote will beep and LED stays solid green