Page 13 of 14 Rev: 1/21/2014 7:57 AM
unlinking In-LineLinc from it.
The light turned on by
itself.
Another controller, a timer or
stray X10 signals triggered
In-
.
Install a powerline signal blocker in your home
to keep X10 signals from neighboring homes
from interfering. Consider not using In-LineLinc
If the above doesn't work, perform a factory
reset. See Factory Reset.
In-LineLinc turns on, but
not off, using another
controller.
The load is producing
electrical noise that is
interfering with the receptio
n
Install a powerline noise filter (such as
FilterLinc) between the load and In-LineLinc.
Install additional INSTEON devices to boost
the INSTEON signal.
Increase the X10 signal strength with an
INSTEON-compatible X10 booster to
overcome the power line noise.
Remove the X10 address from the button on
your INSTEON controller so it doesn’t send
both INSTEON and X10 commands.
In-LineLinc doesn't
respond to X10 address
A1 when I first set it up.
-only
In-LineLinc
does not
have an X10 address set up at
the factory.
Set up an X10 address. See Adding an X10
Address.
In-LineLinc is locked up.
A surge or excessive noise on
the powerline may have
glitched it.
Pull the Set button on In-LineLinc all the way
out to create an air gap, wait 10 seconds, then
push it back in until it’s flush with the trim frame
(don't push it all the way in).
If the above doesn't work, perform a factory
reset. See Factory Reset.
my responder, but
nothing happens when I
send an ON command
Your responder may be linked
at its off state.
Relink your responder to In-LineLinc, while the
responding device is on.
My controller can turn off
In-LineLinc, but In-
LineLinc does not turn
on when I send an ON
command from my
-LineLinc may be linked at
Relink In-LineLinc to your controller, while the
load is on.
If you have tried these solutions, reviewed this Owner's Manual, and still cannot resolve an issue you are
having with In-LineLinc Relay, please call the INSTEON Support Line at 1-800-762-7845.
