A SERVICE OF

logo

Open as PDF
next previous
Page 5 of 14 Rev: 1/21/2014 7:57 AM
6) Referring to the diagrams below, use the included wire nuts to connect the fixture’s Line, Load,
Neutral, Ground and Sense wires (if using) to In-LineLinc’s corresponding wires.
7) Enable power to the switch from the circuit breaker or fuse panel.
8) Use In-LineLinc’s On and Off buttons to test that In-LineLinc is installed properly.
The load will turn on and off.
9) Link In-LineLinc to an INSTEON controller.
10) Gently place In-LineLinc into the junction box, making sure nothing could accidentally press the
buttons on its face.
11) Reinstall the fixture.
Above: wiring In-LineLinc Relay without Sense; below, wiring In-LineLinc with Sense.