A SERVICE OF

logo

75
Listening to the Radio—Continued
Notes:
The SIRIUS information on the Satellite Radio screen
is only displayed when the Satellite Radio mode is set
to SIRIUS or XM/SIRIUS (see page 68).
If you’re using both XM Satellite Radio and SIRIUS
Satellite Radio and the Satellite mode is set to XM/
SIRIUS (see page 68), signal strength meters for both
systems appear on the same screen.
SIRIUS Satellite Radio Messages
The following messages may appear while using SIR-
IUS Satellite Radio.
ACQUIRING
The SiriusConnect receiver is acquiring the signal or
no signal is present. Make sure the SiriusConnect
Home tuner is connected properly and that there are
no obstacles close by.
ANTENNA ERROR
Make sure the SiriusConnect Home tuner is con-
nected properly.
SUB UPDATED
Displayed while your subscription is being updated.
No operations can be performed until this message
has cleared.
UPDATING XXX%
Displayed while the channel map is being updated.
Wait until the updating is complete.
UPDATING
Displayed while the SiriusConnect receiver’s firm-
ware is being updated.
INVALID CHANNEL
Displayed if you select an unavailable channel.
CALL SIRIUS
Displayed when you select a channel to which you
are not subscribed. Call SIRIUS if you want to sub-
scribe.
CHECK SR TUNER
Displayed if the SiriusConnect receiver is not con-
nected. Make sure the SiriusConnect receiver is con-
nected properly, and make sure its AC adapter is
plugged in.
3
Use the Up and Down [ ]/[ ]
buttons to select “4. Satellite
Radio,” and then press [Enter].
The Satellite Radio menu appears.
Adjust the position of the Sirius-
Connect Home antenna so that
the SAT/TER signal strength bar
is as long as possible.
Terrestrial (TER) signals are only avail-
able in certain areas.
So long as the signal strength is good,
you can enjoy SIRIUS Satellite Radio
by using either satellite or terrestrial
reception.
4-4. Satellite Radio
Satellite Terrestrial
SIRIUS ID
SIRIUS Antenna Aiming
- - - - - - - - - - - -
DTR-6.8_En.book Page 75 Wednesday, June 20, 2007 11:54 PM