Hardware Installations and Upgrades
Intel
®
Server Chassis SR1450 User Guide 31
Installing and Removing a Hard Disk Drive
Up to three hard drives of one of the following types can be installed, depending on the hard drive
installation option used in your server chassis and the drives supported by your server board.
Three hot-swap SCSI drives if the SCSI backplane is installed.
Three hot-swap SATA drives if the SATA backplane is installed.
✏ NOTE
The Intel Server Chassis SR1450 does not support all hard drives. See
“Additional Information and Software” for an Internet link to a list of
supported hardware.
CAUTION
If you install less than three drives or devices, empty drive bays must be
occupied by carriers with baffles to maintain proper system cooling.
To avoid possible damage to your chassis, DO NOT USE older style drive
carriers received with other Intel server chassis.
Removing a SATA or SCSI Hot-swap Hard Disk Drive
1. Remove the front bezel if it is installed. For instructions, see “Removing and Installing the
Front Bezel.”
2. Press in on the green latch at the front of the hard drive carrier. See letter “A” in the figure
below.
3. Pull out on the black lever and slide the carrier from the chassis. See letter “B” in the figure
below.
TP01599
B
A
Figure 16. Removing a Hot-swap Hard Drive Carrier from Chassis
